Cables and Adapters

Magico Key is intended for testing charging ports on iOS and Android phones.

This adapter is intended for testing fast chargers produced by Apple and other brands. Works with V1S Pro/V1SE programmers.

This adapter allows you to convert 13 series sockets to 15 series socket to repair Face ID feature.

This cable allows you to reboot the device into Emergency Download (EDL) mode with no testpoints or server authentication.

This cable is intended for quick entering Recovery mode on the latest iPhones and iPads with a Type-C port.

This adapter is intended for repairing True Tone feature on iPhone with or without the original screen.

This board is used for reading the original iPhone Face ID data and writing these data to the replacement FPC cable. Used with V1SE/V1S Pro programmer only.

These service cables are intended for servicing MacBook batteries using the MBRT programmer.

ICFRIEND Easy UFS 3 in 1 is intended for Z3X Easy JTAG Plus Box and allows you to read / write data on the UFS BGA153, UFS / EMMC BGA254, UFS BGA297 chipsets.

This pin conector is intended for reading, writing, and erasing UFS data in ISP mode and PWM1-4 modes using Medusa Pro II.

The JCID iBooter allows you to analyze current consumption during the boot process of Android and iOS devices. It helps to identify faults that may not be discovered through physical inspection alone, such as short circuits or battery problems.

This cable is used with the JCID iBooster Current Analyzer for checking startup current, output voltage, load voltage, power output, and fault current analysis on iPhone X-11 series.

This service cable is intended for servicing the A2669 battery (MacBook Air M2 (A2681), Air M3 (A3113)) using MBRT.

MiPi Tester eMMC / UFS ISP Adapter allows you to service any device with ISP pinouts via UFS/eMMC interface.

This service cable is intended for servicing the A2797 battery used in MacBook Air 15″ (A2941, A3114, A3241) using MBRT programmer.

MiPi Tester eMMC / UFS ISP Adapter allows you to service any device with ISP pinouts via UFS/eMMC interface. Intended for Easy UFS kits and Z3X Easy Jtag Plus.

This socket adapter is intended for the Flash 64 programmer.

This socket adapter is intended for the Flash 64 programmer.

This socket adapter is intended for the Flash 64 programmer.

This socket adapter is intended for the Flash 64 programmer.

This adapter is intended for repairing True Tone feature on iPhone with or without the original screen.

This adapter is compatible with UFI-Box. Supported BGA types: 169-FBGA,153-FBGA,162-FBGA,186-FBGA

This adapter is compatible with UFI-Box. Supported BGA types: BGA221 / BGA254

Z3X Easy-Jtag Plus BGA-153 Socket Adapter