Adapters

JC iHeater Pro is a heating platform for repairing (separating by heating) of motherboards and screen frames on iPhone X - 15 Pro Max.

New platform for convenient and effective BGA reballing of EMMC / EMCP / UFS chips (BGA153 / BGA162 / BGA169 / BGA186 / BGA221 / BGA254 / BGA297). Fixed Plate and Magnetic Base Holder are included.

Intended for direct EMMC memory chips connection with the wide range of supported BGA types.

QianLi iCopy Battery Detection Connection Board allows the users of QianLi iCopy Plus 2.1 programmer (and later versions) to test iPhone batteries.

BGA70 NAND module for reading / writing / formatting NAND data of iPhone 5 SE - 7 Plus / iPad 5 / 6 / 7 / iPad Pro 1 / 2. Intended for JC V1S Pro Programmer.

BGA315 NAND module for reading / writing / formatting NAND data of iPhone SE 3 / 14 / 14 Plus / 14 Pro / 14 Pro Max / iPad 10 / Air 5 / iPad Pro 6. Intended for JC V1S Pro Programmer.

QianLi iCopy Battery Detection Connection Board allows the users of QianLi iCopy 2.1 programmer (and later versions) to test iPhone batteries.

Fix matching problems after rear cameras replacement on iPhone XR / X / XS / XS Max / 11 / 11 Pro / 11 Pro Max / 12 / 12 Pro / 12 Pro Max / 12 mini.

Intended solely for work with JC P15 Programmer.

Intended solely for work with JC P15 Programmer.

Intended solely for work with JC P15 Programmer.

It is an adapter for JC V1SE / V1S Pro programmer that solves problems caused by non-genuine iPhone batteries.

This is an adapter for JC V1SE / V1S Pro programmer that is intended for reading and writing vibrator data.

Magico Key is intended for testing charging ports on iOS and Android phones.

This adapter is intended for testing fast chargers produced by Apple and other brands. Works with V1S Pro/V1SE programmers.

This adapter allows you to convert 13 series sockets to 15 series socket to repair Face ID feature.

This adapter is intended for repairing True Tone feature on iPhone with or without the original screen.

This board is used for reading the original iPhone Face ID data and writing these data to the replacement FPC cable. Used with V1SE/V1S Pro programmer only.

ICFRIEND Easy UFS 3 in 1 is intended for Z3X Easy JTAG Plus Box and allows you to read / write data on the UFS BGA153, UFS / EMMC BGA254, UFS BGA297 chipsets.

ICFRIEND Easy UFS 6 in 1 is intended for Z3X Easy JTAG Plus Box and allows you to read / write data on the UFS chipsets (BGA153, BGA254, BGA297).

This pin conector is intended for reading, writing, and erasing UFS data in ISP mode and PWM1-4 modes using Medusa Pro II.

The JCID iBooter allows you to analyze current consumption during the boot process of Android and iOS devices. It helps to identify faults that may not be discovered through physical inspection alone, such as short circuits or battery problems.

MiPi Tester eMMC / UFS ISP Adapter allows you to service any device with ISP pinouts via UFS/eMMC interface.

MiPi Tester eMMC / UFS ISP Adapter allows you to service any device with ISP pinouts via UFS/eMMC interface. Intended for Easy UFS kits and Z3X Easy Jtag Plus.