Cables and Adapters

This adapter is intended for the quick localizing of phone motherboard failure points. Not a standalone solutions. Requires V1SE / V15 Pro programmer and JC Drawing software.

This JCID Flex Cable is intended for replacing the faulty battery flex cable on iPhone 14 / 14 Plus. Works with JC V1S / JC V1SE / JC V1S Pro Programmer

This JCID Flex Cable is intended for replacing the faulty battery flex cable on iPhone 14 Pro / 14 Pro Max. Works with JC V1S / JC V1SE / JC V1S Pro Programmer

Qianli Macaron Spot Welder (2nd Gen) is used to solder the BMS board of batteries on iPhone of 11, 12, 13, and 14 series.

For True Tone repair while replacing with either an original factory screen or a compatible brand screen.

For True Tone repair while replacing with either an original factory screen or a compatible brand screen.

This adapter is intended for repairing True Tone feature on iPhone with or without the original screen.

This adapter is intended for fault analysis and reading data of Type-C tail plugs.

This adapter is intended for fault analysis and reading data of Lightning tail plugs.

This adapter allows users of iCopy programmer to repair True Tone feature on iPhone 12 / 13 series.

Allows you to activate / read / write Face ID on iPhone X / 11 / 12 / 13 / 14.

This adapter allows to read / write iPhone and iPad chip data.

A spot welding tool that allow you to solder BMS boards of phone batteries.

This adapter is intended for Z3X Easy-Jtag Plus boxes.

This holder with stencil net set is intended for reballing of 99% ICs on the market such as A8-A17 for iPhone 6 up to 15 series, as well as Qualcomm Snapdragon, Hisilicon Kirin, MTK Dimensity, and Samsung Exynos series.

ICFRIEND Easy UFS 6 in 1 is intended for Z3X Easy JTAG Plus Box and allows you to read / write data on the UFS chipsets (BGA153, BGA254, BGA297).

This cable is used with the JCID iBooster Current Analyzer for checking startup current, output voltage, load voltage, power output, and fault current analysis on iPhone 15 series.

This cable is used with the JCID iBooster Current Analyzer for checking startup current, output voltage, load voltage, power output, and fault current analysis on iPhone 7-8P series.

MiPi Tester eMMC / UFS ISP Adapter allows you to service any device with ISP pinouts via UFS/eMMC interface.

MiPi Tester eMMC / UFS ISP Adapter allows you to service any device with ISP pinouts via UFS/eMMC interface. Intended for Easy UFS kits and Z3X Easy Jtag Plus.

This eMMC/UFS 2 in 1 Flex cable set is intended for the Flash 64 programmer.

This ISP Adapter is intended for the Flash 64 programmer. Manufactured by ICFRIEND.

MiPi Tester UFS/eMMC ISP S2 allows you to service any device with ISP pinouts via UFS/eMMC interface. Intended for MiPi Box.

This UFS ISP adapters kit is intended for work with Flash64 Box and Easy JTAG Plus Box.