Adapters for Apple

This board is used for reading the original iPhone Face ID data and writing these data to the replacement FPC cable. Used with V1S/ V1SE/V1S Pro programmer only.

This adapter is intended for fault analysis and reading data of Type-C tail plugs.

With IP-Box 2 and SPI PCB you can read / write / fix base SPI Flash IC (for example, fix iTunes 1.16...error and much more)

Naviplus PRO 3000S module for iPad 4

Fast change of the following underlying data: SN, country, Bluetooth address, Wi-Fi address.

JC Pro 1000S 32/64 Bit NAND Module is a new JC Pro 1000S PCIE module able to work on JC software platform and on JC Pro1000S programmer.

JC Pro 1000S Module for iPhone 8 / 8 Plus / X is a new JC Pro 1000S PCIE module able to work on JC software platform and on JC Pro1000S programmer.

Naviplus PRO 3000S 2 in1 Adapter for iPad 5 Air / iPad 6 Air 2

Easy 5 / 6 for iPad 5 Air / iPad 6 Air 2 NAND Fixture allows you to work with iPad Air / Air 2 without removing NAND flash memory.

Naviplus PRO 3000S Adapter for iPhone 8 / 8 Plus / X allows you to read the firmware data of the original screen and write the information to the replacement screen.

This PCB board is intended for JC V1 Programmer and allows you to service iPhone 11 / 11 Pro as well.

This adapter allows you to enter the Purple Screen mode on iPad 2 / 3.

Magic AWRT Adapter is intended for solving service problems with iWatch SE/S1/S2/S3/S4/S5/S6 (38 mm / 42 mm / 40 mm / 44 mm)

QianLi iSocket is intended for after-repair testing of mother board of iPhone X / XS / XS Max. Time saver and a handy tool for anyone dealing with iPhone hardware repair

QianLi iSocket is intended for after-repair testing of mother board of iPhone 11 / 11 Pro / 11 Pro Max. Time saver and a handy tool for anyone dealing with iPhone hardware repair

Solves the problem with True Tone and Face ID caused by not original FPC flex cable on iPhone 8 / 8 Pro / X / XR / XS /XS Max / 11 / 11 Pro / 11 Pro Max / 12 / 12 Pro / 12 Pro Max. Works together with JC Pro1000S programmer.

JC V1S FPC Receiver Detection Board is intended for restoring iPhone True Tone / Face ID functions.

JC iHeater Pro is a heating platform for repairing (separating by heating) of motherboards and screen frames on iPhone X - 15 Pro Max.

This board allows you to repair and activate Face ID feature on iPhone X - 14 series. Intended for iCopy programmers. Not a standalone solution.

JC V1SE/V1S Pro FPC Receiver Detection Board is intended for restoring iPhone True Tone / Face ID functions.

Qianli Macaron Spot Welder (2nd Gen) is used to solder the BMS board of batteries on iPhone of 11, 12, 13, and 14 series.

It is an adapter for JC V1SE / V1S Pro programmer that solves problems caused by non-genuine iPhone batteries.

This is an adapter for JC V1SE / V1S Pro programmer that is intended for reading and writing vibrator data.

For True Tone repair while replacing with either an original factory screen or a compatible brand screen.