eMMC/JTAG Adapter for RIFF Box 2

id: 870741
id: 870741 0.015 kg
Rate product
eMMC/JTAG adapter for RIFF Box 2 allows you to connect in ISP mode (directly onto your phone without removing the EMMC) or Direct (by removing the BGA soldering and the corresponding memory fields or using adapter)
Discontinued
Contact
sales team
Discontinued
Contact
sales team
Impossible to estimate the shipping cost
Overview
Warranty
Overview

Adapter eMMC/JTAG for RIFF Box 2

Adapter eMMC/JTAG for RIFF Box 2 - RC2000 allows you to perform a very simple phone repair by JTAG, using IDC 20-pin connector, known from previous RIFF. It is also supports eMMC, using latest 30-pin connector (IDC 30-pin). Thus you can repair phones with blocked JTAG access (GT-i9300 / N7100 / N719 / N7102, etc.), repair phones with damaged JTAG points/pads (access to ROM2 by EMMC) or read/write EMMC in case then the data recovery/analysis is required. Using this adapter, you can perform format EMMC or low-format (in case of damage EMMC), CMD42 lock/decode/password reset or Samsung eMMC factory format.

Adapter eMMC/JTAG for RIFF Box 2 - Output Signals:

  • JTAG: GND, TRST, TDI, TMS, TDO, TCK, RTCK, NRST, VCC
  • eMMC: DAT0, DAT1, DAT2, DAT3, CLK, CMD, GND, VCCQ, VCC 3.3V, RST
  • GPIO: 1, 2, 3, 4, 5, 6, 7, 8, 10, 11, 12, 13, 14, 15, 16, 17, 19, 20, 21, 22, 23, 24
  • SDW: DI0, CLK, D0, GND

Adapter eMMC/JTAG for RIFF Box 2 - Features:

  • eMMC/SD read info, browse through OCR, CID, CSD (and EXT_CSD for eMMC only) registers’ fields, edit separate fields and write back to card, read/write eMMC card’s MCU’s internal firmware, etc.
  • eMMC Firmware Update option
  • eMMC Firmware Read option
  • CMD42 lock/decode functionality for eMMC - user can set/change/remove password to protect/unprotect (lock/decode) the user area partition
  • User area partition forced erase, used to erase locked user area partition and to reset device lock/decode state and password (CMD42)
  • Samsung factory erase option, which erases and re-formats the Samsung eMMC chips

Picture of adapter connected to RIFF Box 2 with IDC20 connector for JTAG operations:

New XPIN Clip is here!

Picture of adapter connected to RIFF Box 2 with IDC30 connector for eMMC operations:

New XPIN Clip is here!

Adapter eMMC/JTAG for RIFF Box 2 - Package Content:

  • Adapter eMMC/JTAG – 1 pc.
  • FF 10cm cables – 10 pcs.
Warranty
eMMC JTAG Adapter for RIFF Box 2 - /*Short description|product*/
ID: 870741
eMMC/JTAG Adapter for RIFF Box 2
Discontinued
Contact
sales team

Customers Feedback

Chat with us
English Online Español Offline Русский Online Português Offline
Sales chat
 English online
 Español offline
 Русский online
 Português offline
Contacts
Phone:
Email:
Compare
No items in compare list
Sales chat
Contacts
Compare